When you export DWGs in Revit, filled regions are not exported correctly if some filled regions overlapped each other on the views. Here is a example. In Revit 2017, there […]
In Revit, you can choose which revisions need to be showed up on each sheet using “Revisions on Sheet” on the properties. However, sometimes some revisions are greyed out, so […]
In general, a numerical value of Revit dimension can be replaced text only, but you can change a numerical value using Unicode. This method might be useful when you need […]
Have you ever tried to place a spot slope dimension on ramp in Revit? You cannot place it on ramps because of some reasons, then how could it be achieved […]
Typically most users just use a category-based filter in Revit, but sometimes a selection-based filter is very useful if there is no rule to be applied. Selection-Based filter allows to […]
If you need to attach multiple columns or walls to a roof, you can attach those elements quickly & easily using “Attach Top/Base”. This short video clip shows how to […]
You can place a dimension between circles using the parameter called “Center Mark Visible” because you cannot snap center points of circles.